3. Projecting an Image (Basic Operation)
Adjusting the Picture Size and Position
Place your projector on a flat level surface and ensure that the projector is square to the screen.
Lift the front edge of the projector to center the image vertically.
If the projected image does not appear square to the screen, use the Keystone feature for proper adjustment. See pages 33 and 43.
Rotate the front of the projector right or left (to the right in this example) to center the image horizontally on the screen.
Adjust the Tilt Foot
1. Lift the front edge of the projector. | Adjustable Tilt |
| Foot Button |
2.Push up and hold the Adjustable Tilt Foot Button on the front of the projector to extend the adjustable tilt feet.
3.Lower the front of the projector to the desired height.
1
2 
4.Release the Adjustable Tilt Foot Button to lock the Adjustable tilt foot.
There is approximately 7 degrees of up and down adjustment for the front of the projector.
Adjusting the height of a projected image or changing projection angle will run the Auto Keystone correction function to quickly correct the vertical distortion. The "Keystone" screen will be displayed.
Adjustable Tilt Foot
3
For operating the "Keystone" screen, see " Correcting Key- | 4 |
stone Distortion" on page 33. |
|
NOTE: Your "Keystone" correction data can be reset by pressing and holding the 3D REFORM button for a minimum of 2 seconds.
The rear foot height can be changed. Rotate the rear foot to the desired height, but the vertical distance from the bottom to the
desk or floor should be 1” (25mm) to make the projector horizon- Up tal on the flat surface.
Up
Down
CAUTION
Do not use the
damage to the projector.
31