Troubleshooting
7. Troubleshooting (continued)
Situation
Reference
page
| Check the following settings on the Main and |
| |
The STACK | Sub projectors. |
| |
- STANDBY MODE in SETUP menu: | 5 | ||
menu is not | |||
NORMAL | |||
functioning. |
| ||
- COMMUNICATION TYPE under |
| ||
|
| ||
| COMMUNICATION in SERVICE menu: |
| |
| OFF |
| |
| - STACK LOCK in SECURITY menu: OFF |
| |
| The remote control is pointed at the Sub |
| |
The projector | projector. |
| |
does not respond When operating in Intelligent Stack, only the | 3 | ||
to the remote | Main projector is capable of receiving remote | ||
| |||
control. | control signals. Therefore, point the remote at |
| |
| the Main projector. |
| |
| The two images are not superimposed | 6 | |
The images are | correctly. | ||
| |||
either out of | Use the ZOOM, FOCUS and LENS SHIFT |
| |
focus or not well- features to fine tune the superimposed |
| ||
superimposed. | images. If needed, adjust PERFECT FIT and | 11 | |
| KEYSTONE as well. |
| |
| The two images are adjusted differently. |
| |
The images | Try these steps: |
| |
|
| ||
from the two | - Press the AUTO button on the remote | 49 | |
projectors do | control or execute AUTO ADJUST | in Operating | |
not superimpose | EXECUTE on each of the projectors. | Guide | |
properly even | - Adjust H POSITION and V POSITION on | 48 | |
after finely | each of the projectors. | in Operating | |
adjusting the | - Check the RESOLUTION setting in the | Guide | |
image. | INPUT menu, and change the setting to | 53 | |
| match if the setting differs between Main | in Operating | |
| and Sub. | Guide | |
If you require more information on Instant Stack, please consult your dealer.
33
