Selecting lamp switching mode | InFocus IN5134A, IN5132, IN5135

STACK menu settings

3.4 Selecting lamp switching mode

The following setting is only necessary when ALTERNATE is selected in the LAMP MODE dialog. (15) Select the AUTO or NORMAL lamp switching mode when using ALTERNATE.

1.Highlight ALTERNATE MODE in the STACK menu with the ▲/▼ buttons, then press the ► button to display the ALTERNATE MODE dialog.

2.Use the ▲/▼ buttons in the dialog to highlight AUTO or NORMAL. AUTO: Turns on the projector with the lowest lamp hours. NORMAL: Turns on the projector that was not used previously.

3.Press the ◄ button to return to the previous menu, or press the ► button to save the setting. (19)

NOTE • The ALTERNATE MODE dialog can be operated on the Main projector when ALTERNATE is selected in the LAMP MODE dialog.

•To maintain the quality and reliability of the two projectors, the projector with the highest lamp hours may be turned on even if AUTO is selected.

17

Image 17

InFocus IN5134A, IN5132, IN5135, IN5144A, IN5142, IN5145 user manual Selecting lamp switching mode

Contents

IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 Features Contents Introduction Remote control for Intelligent Stack and Simple StackBasic information and preparations Instant Stack Introduction Preparing for Intelligent Stack Installation Setting up Set a Installing the first projector Set aDeciding the installation position Advanced Menu Option Service Communication Stack Setting up Set B Installing the second projector Set BConnecting projectors Installation Confirming Main and Sub settings For Intelligent Stack users Fine adjusting image position For Simple Stack users Displaying Stack menu Stack menu settings Selecting Main, Sub or off Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation mode Selecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Dialog from Stack menu Exiting Intelligent Stack menuStack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Example Service Connecting an RS-232 cable Connecting cables Inputting the image from Main to Sub Connecting signal cablesComputer IN1 and IN2 Inputting the image to Sub and Main individually Checking Main projectors operating status Setting input ports using menuPreparing for menu operations Starting up Main projector Inputting image from Main to Sub Computer signal Setting the menu Inputting image to Sub and Main individually Setting input ports using menu Restrictions on the Sub projector Restrictions on Schedule functionRestrictions on the Main projector Restrictions on Schedule function Troubleshooting Two images are adjusted differently Remote control is pointed at the SubProjector Two images are not superimposed