Confirming Main and Sub settings | InFocus IN5132, IN5134A manual

Installation

2.4 Confirming Main and Sub settings

1.Press the MENU button on the remote control for Main (Set B).

NOTE • When Intelligent Stack is in use, only Main will be able to receive remote control signals. Sub will not respond to remote control signals.

2.The following dialogs appear on the lower right screen.

Main (Set B)

Sub (Set A)

3.If you press the ► button, the dialog closes and the Main (Set B) menu will appear when MAIN is highlighted.

If you press the ◄ button, the dialog closes and the menu will disappear.

NOTE • If these dialogs are not displayed on screen, check the RS-232 connection (8) and the MAIN or SUB settings in the STACK MODE dialog. (14)

10

Image 10

InFocus IN5132, IN5134A, IN5135, IN5144A, IN5142, IN5145 user manual Confirming Main and Sub settings

Contents

Features IN5132/IN5142/IN5134/IN5134a IN5144/IN5144a/IN5135/IN5145 Contents Basic information and preparations Remote control for Intelligent Stack and Simple StackIntroduction Instant Stack Introduction Installation Preparing for Intelligent Stack Deciding the installation position Installing the first projector Set aSetting up Set a Advanced Menu Option Service Communication Stack Connecting projectors Installing the second projector Set BSetting up Set B Installation Confirming Main and Sub settings Fine adjusting image position For Intelligent Stack users For Simple Stack users Stack menu settings Displaying Stack menu Selecting Main, Sub or off Selecting lamp operation mode Only for IN5142, IN5144, IN5144a and IN5145 Selecting lamp operation mode Selecting lamp switching mode Selecting input source for Sub Stack menu Exiting Intelligent Stack menuDialog from Stack menu Important information for Intelligent Stack USB Type A, USB Type B, LAN Service Example Connecting cables Connecting an RS-232 cable Computer IN1 and IN2 Connecting signal cablesInputting the image from Main to Sub Inputting the image to Sub and Main individually Preparing for menu operations Setting input ports using menuChecking Main projectors operating status Starting up Main projector Setting the menu Inputting image from Main to Sub Computer signal Inputting image to Sub and Main individually Setting input ports using menu Restrictions on the Main projector Restrictions on Schedule functionRestrictions on the Sub projector Restrictions on Schedule function Troubleshooting Projector Remote control is pointed at the SubTwo images are adjusted differently Two images are not superimposed