NEC MT1065/MT1060 user manual Selecting a Source, Adjusting the Picture Size and Position, E-19

Selecting a Source

Selecting the computer or video source

Using the Remote Control

OFF	ON
	POWER
VIDEO	RGB VIEWER
AUTO ADJ.	LASER

Press any one of the RGB, VIDEO or

VIEWER buttons.

ASPECT	FREEZE 3D REFORM
HELP	POINTER	PIC-MUTE
VOLUME	MAGNIFY	SLIDE
ZOOM	FOCUS	FOLDER
		SLIDE
		LIST

Adjusting the Picture Size and Position

Place your projector on a flat level surface and ensure that the projector is square to the screen.

Lift the front edge of the projector to center the image vertically.

Move the projector left to center the image horizontally on the screen.

NOTE: If no input signal is available, the projector will display a blue background (factory preset).

Selecting from Source List

Source List

Press and quickly release the SOURCE button on the projector cabinet to display the Source list. Each time the SOURCE button is pressed, the input source will change as follows: "RGB1", "RGB2" (computer or DVD with component output) , "Video" (VCR, document camera, or laser disc player), S-Video", "DVI (Digital)", "Viewer" (slides on a PC card), or "LAN" (wired or wireless signal aired from a PC).

To display the selected source, press the ENTER button.

Detecting the Signal Automatically

Press and hold the SOURCE button for a minimum of 1 second, the projector will search for the next available input source. Each time you press and hold the SOURCE button, the input source will change as follows:

→RGB1 → RGB2 → Video → S-Video → DVI (Digital) → Viewer 

*If the projected image does not appear square to the screen then use the 3D Reform feature for proper adjustment. See page E-20.

Adjust the Tilt Foot

1. Lift the front edge of the projector.

Adjustable Tilt Foot Lever

Adjustable Tilt Foot Lever

Adjustable Tilt Foot

2.Push up the Adjustable Tilt Foot Levers on the right and left sides of the projector to extend the adjustable tilt feet (maximum height).

3.Push down the Adjustable Tilt Foot Levers.

If no input signal is present, the input will be skipped. When the input source you wish to project is displayed, release the button.

Press the ENTER button.

4.Lower the front of the projector to the desired height (max. 44.5mm/ 1.8”) and release the Adjustable Tilt Foot Lever to lock the Adjustable tilt foot. There is approximately 10 degrees of up and down adjust- ment for the front of the projector.

WARNING: To avoid premature lamp failure, do not tilt the front of the projector up or down by more than 15° from level.

E-19