NEC NDA-30016-003 manual MAT Assignments, Assignment of MSF Function Key

Roamer Installation Guide MAT Assignments

Chapter 4 MAT Assignments

This guide assumes that data settings that affect the operation of all OAI software on a system-wide basis have already been assigned on the NEAX Maintenance Administration Terminal (MAT). Such settings include system index values and assignment of Interface I/O Port Data in the Interface Processor (IP). For more information about these system data settings and the MAT commands described below, refer to the OAI Module Installation Manual for the NEAX2400 IMS, the NEAX2400 IMS Command Manual, the NEAX2400 IMS Job Specification Manual, and the NEAX2400 IMS Programming Manual.

Assignment of MSF Function Key

Roamer requires MAT assignment of the Mode Set Facility (MSF) to an OAI- assigned function key on all Dterms affected by application. This process involves assigning the MSF and its Operation Code (Op-Code), configured for Roamer in the APM Application Configuration option, to one of the 14 OAI Key Codes. (The MSF Op-Codes range from 128 to 191. These are available for on-screen viewing through the Providers command in the APM Application Configuration option.)

Each of the OAI Key Codes corresponds to an AKY1 Function Key Index (FKI) value which is then assigned to the specific Dterm function key. This process is

illustrated below:

		PBX Correspondence of
		AOKC			AKY1
		OAI		Function
		Key Codes		Key Indices
APM	MAT	1	< . . . .>		34	MAT
Application	AOKC					AKY1
		2	< . . . .>		35
Configuration	Command
						Command
		3	< . . . .>		36
Designation of	Assignment of	4	< . . . .>		37	Assignment of	. . . . .
							. .. .. .. .
Facility (Type)	an OAI Key Code	5	< . . . .>		38	Corresponding	. . .
and its Op-Code	(between 1 and 14)	6	< . . . .>		39	MAT Function
for Use by	to the Same
		7	< . . . .>		40	Key Index to a
Roamer	Facility Type
						specific Dterm
	and Op-Code	8	< . . . .>		41
						Function Key
		9	< . . . .>		42
		10	< . . . .>		43
		11	< . . . .>		44
		12	< . . . .>		45
		13	< . . . .>		46
		14	< . . . .>		47

Figure 4-1 OAI Function Key Assignment

A knowledge of the Dterm stations in the NEAX system and which ones will have access to Roamer is necessary to making the following assignments:

NDA-30016 Revision 3.0 Page 15