NEC NEAX2400IMX system manual Data Programming Procedure DSS/BLF

DATA PROGRAMMING

Data Programming Procedure (DSS/BLF)

2.Data Programming Procedure (DSS/BLF)

When assigning DSS/BLF data, perform the following procedure. “X” indicates the value should be tailored to the existing system.

STEP 1: ASYD

Assign the DSS/BLF to an even-numbered LEN level. (In this example LV 0 is used.) TN : X

STN : 200

LEN : 0 0 0 1 0 0 Even-numbered LEN level

TEC : 1 2 Fixed

RSC : X

SFC : X

Assign a station to be used for programming DSS keys (KYNs 31-60) to the subsequent LENS. (In this example, LV 1 is used.

TN	:	X
STN :		201
LEN :		0 0 0 1 0 1	Subsequent LEN level
TEC	:	1 2		Fixed
RSC :		X
SFC	:	X

STEP 2: AKYD

Assign key data for the 60 DSS keys. The upper 30 DSS keys (KYNs 1-30) are assigned using the first port (LV 0 in this example) and the remaining lower DSS keys (KYNs 31-60) are assigned using the second port (LV 1 in this example). Either KYN 1 or KYN 2 can be assigned first.

Be sure to assign the associated Dterm station number as the “Station Number of Prime Line.”

TN	:	X
STN	:	200 or 201
TP	:	1	Buttons 1-40 are assignable
PRI	:	0
PL TN	:	X	Enter the associated Dterm as a PL STN.
PL STN	:	400
S	:	0	= Off Hook Suppression is off
MWD	:	0
LN PRE	:	0	= Prime Line Pickup

KYN 1 must be programmed as the DSS/BLF station that has been assigned by the ASDT command.

KYN	:	1
KY1	:	2	= Multi Line
KD	:	0	= Line
TN	:	X
STN	:	200 or 201	DSS/BLF number
RG	:	X

CHAPTER 3 ND-70684 (E)

Page 20

Revision 1.0