NEC PlasmaSync 3300 user manual Video, Display Mode, Position Controls

Display Mode

Display Mode provides you information about the current resolution display

and technical data including the horizontal and vertical frequency.

37

Position Controls

The Position controls allow you to adjust the position of the image.

	RGB
Display Mode
Mode	: 640 x 480
H Freq.	: 31.47 kHz
V Freq.	: 60 Hz
H Pol.	: Neg
V Pol.	: Neg
Source	: RGB 1
Memory	: Factory

VIDEO

Display Mode

Mode :NTSC

Source : Video 1

	Position				Position
	Position			Position
➔ Down/Up				Down/Up
	Left/Right		➔ Left/Right
-		+	-			+

Mode	: indicates the resolution of the current input signal (dot x line).
H. Freq	: indicates the horizontal frequency of the current input signal.
V. Freq	: indicates the vertical frequency of the current input signal.
H. Pol	: indicates the polarity of the horizontal sync. signal.
V. Pol	: indicates the polarity of the vertical sync. signal.
Neg	: indicates the polarity is negative.
Pos	: indicates the polarity is positive.
Source	: indicates the current input source.
Memory	: indicates the memory area.
EXIT	: exits to the main menu.

NOTE: Vertical frequencies identified by the OSM System's Display Mode function may exhibit variances from the actual vertical frequency of the connected input source. Vertical frequencies between 60-70 Hz may vary by +/- 3 Hz; vertical frequencies from 70 Hz to 100 Hz may vary by +/-5 Hz. In these situations, it is recommended that the vertical frequency identified by the OSM System Display Mode function be regarded as an approximate

reference within tolerances stated above.

Auto Picture Control (Picture ADJ/Fine Picture)

The Auto picture control allows you to adjust the Picture Adjustment and Fine Picture.

Auto Picture

Auto Picture : Off

➔Picture ADJ Fine Picture

- +

POSITION/CONTROL Up/Down : moves the arrow up or down to select one of

	the choices.
POSITION/CONTROL +/-	: moves the bar to increase or decrease the ad-
	justment.
EXIT	: exits to the main menu.
NORMAL (RASTER)	: resets the current menu control to the factory
	setting.

Position Down/Up	: moves the image vertically up or down.
Position Left/Right	: moves the image horizontally left or right.
POSITION/CONTROL Up/Down	: moves the arrow up or down to select one of
	the choices.
POSITION/CONTROL +/-	: moves the bar to increase or decrease the ad-
	justment.
EXIT	: exits to the main menu.
NORMAL (RASTER)	: resets the current menu control to the factory
	setting.

NOTE:

•The Picture ADJ and Fine Picture features are available only when the Auto Picture is off. The Picture ADJ and Fine Picture features are not available for Video or S-Video source.

•When the Auto Picture is on, the Picture ADJ and Fine Picture adjustments are made automatically.

•The Picture Adjustment control allows you to fine tune the computer image or to remove vertical banding that might appear. This function adjusts the clock frequencies that eliminate banding in the image.

•The Fine Adjustment adjusts the clock phase or reduces video noise, dot interference or cross talk. (This is evident when parts of the image appear to be shimmering.)

38