NEC VT46 user manual Battery Installation, Remote Control Precautions

Battery Installation

1. Push the catch to the right and remove the battery holder.

Catch		A
	H
		N
		A
2032 T		P
		J
R	OL	S
C 3V
ELL

Battery holder

		H
			N
			A
			P
	2032 T		A
			J
			S
R		OL
C		3V
LiCELL

Remote Control Precautions

•Handle the remote control carefully.

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•If you will not be using the remote control for a long time, remove the battery.

•Do not place the battery upside down.

•Keep the coin cell battery out of reach of children so as not to allow them to swallow the cell battery.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to your local regulations.

Operating Range for Wireless Remote Control

2. Remove the old Lithium coin cell and install new one (CR2032).					7m/22 feet
Ensure that the side with the mark “+” is up.
			A		30˚
		H
			N
n		CR2032V		P
				A
				J
M		OL	T	S
	O2-LiCELL				30˚

7m/22 feet

30˚

30˚

3.Push the battery holder back into the remote control until you feel a click.

Remote sensor on	Remote control
projector cabinet

•The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle of the remote sensor on the projector cabinet.

•The projector will not respond if there are objects between the re- mote control and the sensor, or if strong light falls on the sensor. Weak battery will also prevent the remote control from properly oper- ating the projector.

MnO

2-L

iC

		H
			N
			A
	2032 T		P
			A
			J
R		OL	S
C		3V
ELL

E-9