NetComm NP1100 manual Customer Information

Customer Information

ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:

(1)This unit shall be connected to the Telecommunication Network through a line cord which meets the requirements of the ACA TS008 Standard.

(2)This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by the ACA. These standards are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio noise and, if not installed and used in accordance with the instructions detailed within this manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur with the installation of this product in your home or office. If this equipment does cause some degree of interference to radio or television reception, which can be determined by turning the equipment off and on, we encourage the user to try to correct the interference by one or more of the following measures:

•Change the direction or relocate the receiving antenna.

•Increase the separation between this equipment and the receiver.

•Connect the equipment to an alternate power outlet on a different power circuit from that to which the receiver/TV is connected.

•Consult an experienced radio/TV technician for help.

(3)The power supply that is provided with this unit is only intended for use with this product. Do not use this power supply with any other product or do not use any other power supply that is not approved for use with this product by NetComm. Failure to do so may cause damage to this product, fire or result in personal injury.

NP1100 10/100Mbps PCI Bus Fast Ethernet Card	29
YML567 Rev2