DG834GUv5 Wireless Router with Built-in DSL Modem User Manual

Connecting Additional Wireless Client Devices After WPS Setup

You can add more WPS clients to your wireless network, or you can add a combination of WPS- enabled clients and clients without WPS.

Note: Your wireless settings remain the same when you add another WPS-enabled client, as long as the Keep Existing Wireless Settings checkbox is selected in the Advanced Wireless screen (listed under the Advanced heading in the modem router main menu). If you clear this checkbox, when you add the client, a new SSID and passphrase will be generated, and all existing connected wireless clients will be disassociated and disconnected from the modem router.

To add a wireless client device that is WPS-enabled:

1.Follow the procedures in “Using a WPS Button to Add a WPS Client” on page 2-11or “Using PIN Entry to Add a WPS Client” on page 2-12.

2.To view a list of all devices connected to your modem router (including wireless and Ethernet- connected), see “Viewing Attached Devices” on page 4-8.

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless network. You must record, and then manually enter your security settings (see “Using Push 'N' Connect (WPS) to Configure Your Wireless Network” on page 2-10).

To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:

1.Restore the modem router to its factory default settings (press both the Wireless and WPS buttons on the side of the modem router for 5 seconds).

When the factory settings are restored, all existing wireless clients are disassociated and disconnected from the modem router.

2.Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the Wireless Settings screen (see “Using Push 'N' Connect (WPS) to Configure Your Wireless Network” on page 2-10). and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply. Record this information to add additional clients.

3.For the non-WPS devices that you want to connect, open the networking utility and follow the utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, WPA/ PSK + WPA2/PSK security method, and passphrase).

4.For the WPS devices that you want to connect, follow the procedure “Using a WPS Button to Add a WPS Client” on page 2-11or “Using PIN Entry to Add a WPS Client” on page 2-12.

2-14

Configuring Your Wireless Network and Security Settings

v1.0, May 2009

Page 36
Image 36
NETGEAR DG834GUV5 user manual V1.0, May