FS728TP Smart Switch Software Administration Manual
4-26 Configuring Switching Settings
v1.1, September 2009
The Basic STP Configuration screen contains the following fields:
Global Settings
•Spanning Tree State – Select the STP state on the device. The possible field values are:
– Disable – Disables STP on the device.
– Enable – Enables STP on the device. This is the d e fault value.
•STP Operation Mode – Specifies the STP mode enabled on the device. The po ssible field
values are:
– STP – Enables Classic STP on the device.
– RSTP – Enables Rapid STP on the device. This is the default value.
– MSTP – Enables Multiple STP on the device.
• Configuration Name – Enter the user-defined co nfig uratio n name. The maximum lengt h
is 32 characters. The Configuration Name is required as part of the MSTP configuration.
• Configuration Revision Level – Defines an unsigned 16-bit number that identifies the
revision of the current STP configuration. The Configuration Revision Number is required
as part of the MSTP configuration. The possible field range is 0-65535.
Figure 4-17