Applying AC Power | NETGEAR FS 524S, FS 517TS specification

Applying AC Power

The switches do not have an ON/OFF switch; the only method of applying or removing AC power is by connecting or disconnecting the power cord. Before you connect the power cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch. After you select an appropriate outlet, use the following procedure to apply AC power.

1.Connect the female end of the supplied AC power adapter cable to the power outlet on the back of the switch.

2.Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC outlet.

When you apply power:

•The green Power LED on the switch’s front panel goes on.

•The green Link LED on each connected RJ-45 port goes on.

If the green Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, refer to Chapter 5,Troubleshooting.

When power is applied, the switch conducts a power-on self-test (POST) to verify operation. After the switch passes the POST, it is functional and ready to pass data.

installation 4-9

Image 37

NETGEAR FS 524S, FS 517TS manual Applying AC Power

Contents

Stackable Fast Ethernet Switch Statement of Conditions TrademarksCertificate of the Manufacturer/Importer Voluntary Control Council for Interference Vcci Statement Iii EN 55 022 Declaration of Conformance Internet/World Wide Web Customer Support Contents Troubleshooting InstallationTechnical Specifications Cabling Guidelines Connector Pin Assignments Figures Tables TablesPage Description IntroductionIntroduction Features Feature FS517TS Switch FS524S Switch Unique Features Shared Features Package Contents Page Front and Back Panels Physical Description Front and Back Panels of the FS517TS Switch 10/100 Mbps RJ-45 Ports Front and Back Panels of the FS524S Switch Front Panel LEDs LED Descriptions Normal/Uplink Push Button FS524S Only Front Panel RJ-45 Gigabit Copper Port FS517TS OnlyAuto Uplink FS517TS Only Model FS517TS Switch FR314 Router EN524 Hub Page Applications Desktop Switching Stacked Switching Segment Switching and Bridging from 10 Mbps to 100 Mbps Example of Switched Stacking Applications Page Installation Installation Preparing the Site Characteristics Requirements Installing the Switch on a Flat Surface Installing the SwitchInstalling the Switch in a Rack Attaching Mounting Brackets Connecting Devices to the Switch Connecting Devices to the Switch Connecting Switches to the Stack’s Backplane Installation Cabling Two FS517TS Stacked Switches Cabling FS517TS and FS524S Switches Checking the Installation Applying AC Power Page Troubleshooting Chart TroubleshootingTroubleshooting Chart Troubleshooting To is powered on and operating Configuration Additional Troubleshooting SuggestionsSwitch Integrity Network Adapter CardsPage Electrical Specifications Appendix Atechnical SpecificationsNetwork Protocol and Standards Compatibility Data Rate FS524S Switch W 330 mm 13 D 207 mm 8.2 H 43 mm Physical SpecificationsEnvironmental Specifications Electromagnetic Emissions Electromagnetic Susceptibility Safety Agency Approvals Performance Specifications RJ-45 Plug and RJ-45 Connector Appendix B Connector PIN Assignments Pin Channel Description 100 Mbps RJ-45 Plug and RJ-45 Connector Pin Assignments Fast Ethernet Cable Guidelines Appendix C Cabling GuidelinesCabling guidelines Category 5 Cable Twisted Pair Cables Category 5 Cable SpecificationsTable C-1. Electrical Requirements of Category 5 Cable Figure C-1 illustrates straight-through twisted pair cable Patch Panels and Cables Length CablingReturn Loss Near End Cross Talk Next Conclusion Patch Cables Index Environmental Specifications, A-2 Page NETGEAR, Inc