Macintosh Operating System

Mac OS® 8.6 or 9.x

1.Choose Control Panels >TCP/IP from the Apple menu.

2.If not already selected, select Ethernet in the Connect via list.

3.Select Using DHCP Server in the Configure list.

4.Click the close box.

5.If asked if you want to save this configuration, click Save.

6.Go to Restarting the Network.

Mac OS X

1.Choose System Preferences from the Apple menu.

2.Double-click Network.

3.If not already selected, select Built-in Ethernet in the Configure list.

4.If not already selected, select Using DHCP in the TCP/IP tab.

5.Click Save.

6.Go to Restarting the Network.

Linux® or UNIX® Operating System

If you’re installing the firewall with a Linux-based or UNIX-based computer see your system documentation for TCP/IP and networking setup information.

Restarting the Network

Once you’ve set up your computer to work with the firewall, you must reset the network for the devices to be able to communicate correctly.

1.Turn off the DSL or cable modem, wait 15 seconds, and then turn it on again.

Note: If the modem doesn’t have an on/off switch, either pull the modem’s power adapter out of the wall socket or power down the power strip.

2.If the firewall was powered down, power it up again and wait until the Test light turns off.

3.Restart the computer that is connected to the firewall.

9

Page 11
Image 11
NETGEAR FVS318 manual Macintosh Operating System, Linux or Unix Operating System, Restarting the Network