Rear Panel, Label Function Description | NETGEAR PS111W specification

Rear Panel

PRINTERNETWORK

12V DC

Label	Function	Description

PRINTER	Parallel	Accepts an IEEE1284 printer cable that connects
	Printer Port	to the printer.

NETWORK	10/100	Auto-sensing 10/100 Mbps Ethernet port for direct
	BASE-T	connection to a 10 Mbps or 100 Mbps port on a switch
	Network Port	or hub.

A small	Diagnostic	Briefly pressing the button has no effect. Pressing the
button	and Restore-	button for two seconds will print the status of the print
with no	to-default	server, including wired and wireless information, on the
label	Button	attached printer.
		Note: This is the best way to obtain the IP address
		of the print server, since the default setting for the
		PS111W is DHCP.
		Turn the power off, hold the Reset Button.
		Powering on the print server and holding this button for
		more than 10 seconds will restore the print server to the
		factory default settings.
		Warning: You will lose the current configuration in
		the PS111W, so use this function with care.

12V DC	Power Supply	Accepts the 12V 800mA power supply.
	Inlet
		Note: NETGEAR advises that you use genuine
		NETGEAR accessories to avoid damaging the unit.
		For part re-ordering, please refer to the Replacement
		Power Adapter section at the end of this guide.