NETGEAR WG302NA manual This screen shows the following parameters, General Information Fields

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

This screen shows the following parameters:

Table 4-1.	General Information Fields
Field		Description
Access Point Information
Access Point Name (NetBIOS		The default name may be changed if desired.
name)
MAC Address		Displays the Media Access Control address (MAC address) of the
		wireless access point’s Ethernet port.
Country/Region		Displays the domain or region for which the wireless access point is
		licensed for use. It may not be legal to operate this wireless access
		point in a region other than one of those identified in this field.
Firmware Version		The version of the firmware currently installed.
Access Point Mode		Identifies the operating mode of the WG302: Access Point,
		Point-to-point bridge, Multi-point bridge or Repeater.
Current IP Settings
IP Address		The IP address of the wireless access point.
Subnet Mask		The subnet mask for the wireless access point.
Default Gateway		The default gateway for the wireless access point communication.
DHCP Client		Enabled indicates that the current IP address was obtained from a
		DHCP server on your network. Disabled indicated a static IP
		configuration.
Current Wireless Settings
Operating Mode		Identifies the 802.11 operating mode of the WG302.
Wireless Network Name (SSID)		Displays the wireless network name (SSID) being used by the
		wireless port of the wireless access point. The default is NETGEAR.
Channel/Frequency		Identifies the channel the wireless port is using. 11 is the default
		channel setting. See “Wireless Channels” on page B-7 for the
		frequencies used on each channel.
WEP/WPA		WEP/WPA setting.
AutoCell		AutoCell setting.
Rogue AP Detection		Rogue AP detection setting.

4-6 Management

July 2005 v3.0