User’s Guide for the WG602 v3 54 Mbps Wireless Access Point
B-6 Wireless Networking Basics
202-10060-01, September 2004
WEP Shared Key Authentication
This process is illustrated in below.
Figure B-2: 802.11 shared key authentication
The following steps occur when two devices use Shared Key Authentication:
1. The station sends an authentication request to the access point.
2. The access point sends challenge text to the station.
3. The station uses its configured 64-bit or 128-bit default key to encrypt the challenge text, and
sends the encrypted text to the access point.
4. The access point decrypts the encrypted text using its configured WEP Key that corresponds
to the station’s default key. The access point compares the decrypted text with the original
challenge text. If the decrypted text matches the original challenge text, then the access point
and the station share the same WEP Key and the access point authenticates the station.
5. The station connects to the network.
If the decrypted text does not match the original challenge text (i.e., the access point and station do
not share the same WEP Key), then the access point will refuse to authenticate the station and the
station will be unable to communicate with either the 802.11 network or Ethernet network.
INTERNET LOCAL
ACT
12345678
LNK
LNK/ACT
100
Cable/DSLProSafeWirelessVPNSecurityFirewall
MODELFVM318
PWR TEST
WLAN
Enable
Routerwith Integrated
AccessPoint
1)Authentication
requestsent to AP
2)AP sends challenge text
3)Client encrypts
challengetext and
sendsit back to AP
4)AP decrypts, and if correct,
authenticatesclient
5)Client connects to network
802.11Authentication
Shared Key Steps
Cableor
DLSmodem
Client
attempting
toconnect