New Buck Corporation 80ZC manual Corner Location Framing

CAUTION! Refer to chimney manufacturers instructions for assembly and disassembly of

chimney parts. Be sure to follow chimney instructions for proper clearances to combusti- bles and proper air spacing required.

ffi --- Chimney Cap

0--\.--1-Storm Collar

---:f --Roof Flashing

-+Chimney Pipe

,.....e;~~"'-7"'5..-s-'lt-ttt1-- Use Fire Code Sheet Rock

-"'C-~7"''-?.-s-'S1'f--i-H-tt+f--Met al Fire Slop

NOTE:

A Double Header must be used on a

load bearong ....all as illustrated in

F.gure 3.

2" • 4" Studding

"-':H+f--t-+++H+--A Single Header must be Installed above cabinet.

Vert.cal 2" • 4'''smust be turned flat.

NOTE:

Finished wall must be 2" in front of face of Z.C. Cabinet (without hood trim attached) .

WARNING! Install the hearth protector only as specified. The hearth extension must extend a minimum of 16" in front of the fireplace opening and must be 47 1/2" wide mini-

FIGURE 8 CORNER LOCATION FRAMING

10