Framing must be accomplished after the Model
place. The chimney can be installed after framing, but installa - tion is considerably more difficult and, in some cases, impossi-
ble. Therefore, it is recommended that the chimney be installed prior to framing when a choice exists.
'~ ~t:
LJ ± lZ | rr~'Bl.lllzm<f1~mm_" | |
Atlj<lcelll noom 01 | ~ | ~\~ :Jl. |
Exlclior Cha:;e |
|
|
|
| Interior |
|
| Locntion |
FIGURE 6
Above (Figure 6) are framing location examples with depth dimen-
sions for some typical configurations. These are finished meas- urements so install accordingly.
1. Before framing, combustible floor coverings (carpet, tiles, etc.) must be removed to outer dimension of unit framing, includ- ing the 16" x 42 1/2" area for the hearth extension.
FIGURE 1·A:Safety shield for millboard hearth extension.
Attach safety shield using sheet metal screws
WARNING! Install the hearth protector only as specified. The hearth extension must extend a minimum of 16" in front of the fireplace opening and must be 42 1/2" wide mini- mum.
FIGURE
brick or rock hearth (Note: Cut vertical shield to Fit Installation
height as needed. Use 26 'Ga. Mini- mum metal being sure to cover any combustibles on the base.)
o
scews
7
