Remote terminal accessories

•Remote Cord MC-22: Remote shutter release with blue, yellow, and black terminals for connection to a remote shutter- triggering device, allowing control via sound or electronic signals (length 1 m/3 ft 3 in.).

•Remote Cord MC-30: Remote shutter release; can be used to reduce camera shake (length 80 cm/2 ft 7 in.).

•Remote Cord MC-36: Remote shutter release; can be used for interval timer photography or to reduce camera shake or keep the shutter open during a time exposure (length 85 cm/2 ft 9 in.).

•Extension Cord MC-21: Can be connected to ML-3 or MC-series 20, 22, 23, 25, 30, or 36. Only one MC-21 can be used at a time (length 3 m/9 ft 10 in.).

•Connecting Cord MC-23: Connects two cameras for simultaneous operation (length 40 cm/1 ft 4 in.).

•Adapter Cord MC-25: Ten-pin to two-pin adapter cord for connection to devices with two-pin terminals, including the MW-2 radio control set, MT-2 intervalometer, and ML-2 modulite control set (length 20 cm/8 in.).

•GPS Unit GP-1(0 215): Record latitude, longitude, altitude, and UTC time with pictures.

•GPS Adapter Cord MC-35(0 215): This 35 cm (1 ft 2 in.) cable connects the camera to older GARMIN eTrex- and geko- series GPS units that conform to version 2.01 or 3.01 of the National Marine Electronics Association NMEA0183 data format. Only models that support PC interface cable connections are supported; the MC-35 can not be used to connect GPS units via USB. The units connect to the MC-35 using a cable with a D-sub 9-pin connector provided by the manufacturer of the GPS device; see the MC-35 instruction manual for details. Before turning the camera on, set the GPS device to NMEA mode

(4800 baud); for more information, see the documentation provided with the GPS device.

•Modulite Remote Control Set ML-3: Allows infrared remote control at ranges of up to 8 m (26 ft 3 in.).

n

389