3 Chapter
In addition to straightforward tape dubbing, you can also use this unit to dub signals in DVCAM/DV format automatically from the beginning of the tape to the end through the SDTI (QSDI) or i.LINK interface.
To use the SDTI (QSDI) interface, the optional DSBK- 1501 board is required.
When you dub data recorded by a DVCAM camcorder that supports the ClipLink function, you can also include the data stored in the cassette memory.
Notes
• It is not possible to dub signals recorded in DV (LP) |
format. |
Digital dubbing is carried out in the digital format used |
on the source tape regardless of the recording format |
selected on this unit. If the source tape begins with a |
section in which no signals are recorded, the |
corresponding |
of the tape recorded on this unit may have a different |
length depending on the digital format of the source tape, |
the recording format selected on this unit, etc. During |
dubbing, if the digital format of the source tape changes, |
Connections for dubbing via i.LINK interface
To carry out dubbing through the i.LINK interface, connect the i.DV IN/OUT connectors on this unit and the player.
Use the following procedure.
MENU RESET(NO)
1,9
TC
PRESET SET(YES)
7
2
3,4,5
2,4
1 Press the MENU button in the menu control section.
Operation Editing for Functions Convenient
no signals are recorded until the initial digital format is |
restored. No signals are recorded also when the digital |
format used on the player is DV (LP). |
• Regardless of the audio recording mode setting of this |
unit, dubbing is performed with the original audio |
recording mode unchanged |
or |
• Approximately the last 2 minutes of the tape may not be |
copied because of differences in tape lengths. (If an |
index picture is recorded in this portion, it may also not |
be copied.) |
• A continuous recorded section of approximately 5 |
SYSTEM MENU SETUP MENU
AUTO FUNCTION
HOURS METER
Monitor screen
Setup menu
Time counter display
seconds is required before the recording start point. It is |
recommended to record beforehand color bars or a |
similar signal at the start point of the source tape to be |
dubbed on this unit. |
Connections for dubbing via SDTI (QSDI) interface
To perform SDTI (QSDI) dubbing, connect the REMOTE connectors and the SDTI (QSDI) IN/OUT connectors on this unit and a DVCAM device with SDTI (QSDI) connectors.
For details of the connections and switch settings, see “Connections for SDTI (QSDI) Dubbing” on page 90.
2 Press the f or F button to select “AUTO FUNCTION.”
SYSTEM MENU |
| Auto func |
SETUP MENU |
| |
AUTO FUNCTION |
| Time counter display |
HOURS METER |
| |
|
| |
|
|
|
Monitor screen
52 Digitally Dubbing Signals in DVCAM/DV Format