Nikon UPS Stage 4: System Restore and Follow-upMonitoring, Technical Support

UPS/400 . . . an IBM AS/400 UPS power monitoring system . . .

Stage 4: System Restore and Follow-up Monitoring

•If power is returned, all active users are notified and the system is fully restored to its original active state.

•Remaining battery power is monitored by the system administrator through a UPS current status display which visually depicts remaining battery life by means of a “battery life line.”

These stages should not be confused with the six staged intervals used during actual UPS/400 shutdown processing.

USER-CONTROLLED SHUTDOWN PROCEDURES AND MESSAGES

You may define UPS/400 shutdown procedures using the System Attributes display. This display is used to specify the actions to be taken at the six intervals, including Job Queues to be held, Sub-Systems to end, and the severity level of the message to be issued. A complete description of this display and its options are shown on the following pages.

The current UPS Status display can be used to monitor remaining battery life during and after shutdown procedure. The following page shows a flowchart of UPS/400 shutdown activities.

TECHNICAL SUPPORT

For direct technical support on UPS/400 call … (918) 587-1500

Faxes may be sent to …………………………… (918) 587-1536

Modem dial-in for PTF’s and Updates ………… (918) 587-6923

3