A-12 / ENGLISH
AFTER USE
1Raise the Pad Drive Deck (1), then drive the machine to a service area.
2Turn the Master Key Switch (A) OFF (O) and remove the key.
3Remove the burnishing pad, rinse the pad with warm water and hang it up to dry. NOTE: Allow pad to dry completely before using again.
4Check the Dust Collection Bag (5) if over half full or damaged remove and replace with a new bag.
5Check the maintenance schedule and perform any required maintenance.
6Wipe the machine with a damp cloth, then store the machine in a clean, dry place.
MAINTENANCE SCHEDULE
MAINTENANCE ITEM | Daily | Weekly | Monthly | Yearly |
Charge Batteries | X |
|
|
|
Check/Clean/Replace Burnishing Pad | X |
|
|
|
Check/Replace Dust Collection Bag | X |
|
|
|
Check Battery Water Level(s) |
| X |
|
|
Check/Replace Pad Shroud Skirt |
| X |
|
|
Steering Chain Tension |
|
| X |
|
Lubrication |
|
| X |
|
Check Carbon Brush Wear On Pad/Wheel Drive/ Actuator Motors |
|
|
| X |
NOTE: Refer to the Service Manual for more detail on all maintenance items mentioned in this manual.
LUBRICATING THE MACHINE
Locations requiring periodic oiling are:
Qty 1 - Steering Wheel Shaft Universal Joint (oil hole or port)
STEERING CHAIN TENSION
Inspect once a month and make adjustments if needed (refer to the service manual for detailed instructions).
ELECTROMAGNETIC BRAKE
See Figure 4. The Drive / Steer Wheel Assembly (14) has a built in electromagnetic brake that is engaged whenever the Master Key Switch (A) is OFF or the FWD / REV Drive Pedal (8) is in the neutral position. This brake can be manually over ridden if necessary by inserting a medium to large screwdriver behind the Yoke (AA) as shown. This should only be done in the event you need to push or pull the unit.
FIGURE 4