1 - 16 AMERICAN-LINCOLN TECHNOLOGY SMART 2000
OPERATION OF CONTROLS AND GAUGES - Cont.
BATTERY CONDITION METER (See Figure 6)
The battery condition meter is located on the right side of
the instrument panel. The condition meter indicates the
level of charge in the batteries (inspect underload). The
batteries are sufficiently charged when the needle stays in
the green area on the gauge while the machine is being
operated.
Charge the batteries when the needle drops into the red
zone while operating the machine. Do not operate the
machine if the needle stays in the red area.
BATTERY CONDITION LIGHT (See Figure 7)
The meter shows the condition of the battery, while the
machine is running, under load. When the battery voltage
falls below 31-32 volts for longer than 2-3 seconds the low
voltage light will come on and the Brush/Water solenoids
will be shut off automatically. This is a permanent lockout
until the power is turned off to module. The low voltage
lock out can be reset almost immediately by turning off all
power to the module for 3-5 seconds. In a permanent low
battery condition, the machine can be functional only for
one minute periods an then only by turning the ignition off
and on.
SEAT POSITION ADJUSTMENT (See Figure 8)
The seat position adjustment lever is located on the front
of the seat to the left. The lever is spring loaded to the
“LOCK” position.
To adjust the seat, push the lever to the “RIGHT” and
move the seat to the desired position. Then release the
lever to “LOCK” the seat into place.
Figure 7
Figure 8
Figure 6