Manuals / Nilfisk-ALTO / Household Appliance / Vacuum Cleaner

Nilfisk-ALTO 46/53 manual Machine Preparation, Preparing The Machine For Operation

Models: 46/53

1 49

Download 49 pages 30.77 Kb

Page 11

MACHINE PREPARATION

MACHINE PREPARATION

C1694c

FIGURE 1

YOUR ATS 46/53 BATTERY MACHINE HAS BEEN SHIPPED COMPLETE, BUT DO NOT ATTEMPT TO OPERATE WITHOUT FOLLOWING THESE INSTRUCTIONS.

PREPARING THE MACHINE FOR OPERATION

*Uncrate the machine and carefully remove from skid to prevent damage.

*The ATS 46/53 machines that are shipped without batteries have the (+) positive drive motor lead disconected.

*Open the battery compartment and connect the (+) positive motor lead to the top terminal post (the wire “P” is also attached to it). Tighten the terminal nut.

*Install the scrub brushes.

*Check the oil level in the hydraulic reservoir *Install batteries as follows (if not included):

1.Turn the key to the “OFF” position.

2.Raise the Solution Cover to the open position.

3.Use a battery lifting device with a 2500 lbs. (1150 Kg) capacity hoist to lift the battery.

4.Using the lifting device, lower the 36 volt battery into the battery compartment directly in front of the driver’s compartment. Orient the cables & plug them in as required.

5.Plug the polarized connector from the battery into the 36-volt plug provided.

WARNING

Hydrogen gas is formed during the charging operation and is explosive! Only charge batteries in a well-venti- lated area with the lid open. Avoid any open flame or electrical sparks. Pulling out the charger plug with the timer on will cause an arc and must be avoided.

American-Lincoln	1-11
ATS 46/53 Battery

Image 11

Nilfisk-ALTO 46/53 manual Machine Preparation, Preparing The Machine For Operation

Contents

OPERATOR’S ATS 46/53 BATTERYPARTS LIST American-Lincoln TechnologyAmerican-Lincoln TABLE OF CONTENTSATS 46-53Battery SERVICE INSTRUCTIONS ATS 46/53 BatterySERVICE CHART SERVICE PRECAUTIONSCHAPTER 3 OPTIONS TRAVEL SPEED CLEANING PATHDIMENSIONS WEIGHTHOPPER WARRANTYSQUEEGEE TANKS65.41 cm MACHINE DIMENSIONSATS 46/53 Battery American-LincolnSTANDARD HARDWARE & TORQUE VALUES The torque tolerance is ± on torque valuesHYDRAULIC TORQUE REQUIREMENTS Millimeter DECIMAL-METRICCONVERSION TABLEFraction DecimalPREPARING THE MACHINE FOR OPERATION MACHINE PREPARATIONREAD THE INSTRUCTION BOOK SAFETY INSTRUCTIONSDANGER 1-13 ATS 46/53 BatteryAmerican-Lincoln American-Lincoln ATS 46-53Battery1-14 HORN BUTTON See Figure LIGHT SWITCH See FigureOPERATION OF CONTROLS AND GAUGES KEY SWITCH See Figure HOURMETER CONDITIONC1700 FILTER SHAKER SWITCH See FigureHOPPER SAFETY LOCK ARM See Figure TO ENGAGE THE SAFETY ARMMAIN SIDE BROOM ADJUSTMENT See figureMAIN BROOM ADJUSTMENT See Figure SIDE BROOM LEVERSCRUB DECK SWITCH See Figure SCRUB DECK SWITCHSWITCH DUST CONTROL SWITCH See FigureTO DISCONNECT WATER HOSE SOLUTION CONTROL See FigureNON-RECYCLINGOR STANDARD SCRUBBING SYSTEM RECYCLING OR ESP & AUTOFIL SYSTEMOPERATION OF CONTROLS AND GAUGES FOOT PEDAL ACCELERATOR PARKINGFOOT PEDAL BRAKEHOPPER DUMP DOOR LEVER - See Figure HOPPER LIFT LEVER - See FigureTURN SIGNAL - 4-WayOption See Figure TURN SIGNALSWITCH SWITCHFRONT COVER LATCH See Figure C1719C1718 FILTER PANEL LATCH See FigureCOMPARTMENT HYDRAULIC RESERVOIR LEVEL SIGHT GAUGEMAIN BROOM COMPARTMENT DOORS See Figure MAIN BROOMHOPPER FILTER COVER See Figure HOPPER DOOR LEVER See FigureHOPPER LIFT LEVER See Figure DETERGENT LOW WARNING LIGHT THE ESP RECYCLING SYSTEM ON/OFF SWITCHSOLUTION LEVEL WARNING LIGHT THE ESP RECYCLING CONTROL PANEL See FigureRECOVERY SOLUTION TANKDETERGENT TANK SOLUTION TANK RECOVERYORIFICE DUST CONTROL PRE-STARTCHECKLISTSTARTING BATTERY MACHINES SWEEPING AND DUST CONTROL SYSTEMS-HOWTHEY WORKEMPTYING THE DEBRIS HOPPER POST-OPERATIONCHECKLISTBATTERY CHARGING INSTRUCTIONS STORAGE FOR BATTERY-POWEREDMACHINESMAIN AISLE HELPFUL HINTS FOR CLEANING OPERATION250 HOUR MAINTENANCE CHECKLIST SERVICE CHART50 HOUR WEEKLY MAINTENANCE CHECKLIST 100 HOUR MAINTENANCE CHECKLISTPage SERVICE PRECAUTIONS SERVICE PRECAUTIONSCHECKING THE MAIN BROOM SWEEP PATTERN SWEEPING SYSTEM SERVICE MAIN BROOMADJUSTING THE MAIN BROOM HEIGHT MAIN BROOM LEVEL ADJUSTMENTSIDE BROOM SIDE BROOM SERVICEADJUSTING THE SIDE BROOM HEIGHT SIDE BROOM SERVICEHOPPER HOPPER SERVICECLEANING THE HOPPER CLEANING THE DUST CONTROL FILTERDUST FLAPS REPLACING THE DUST CONTROL FILTERBRAKES BRAKE SERVICEADJUSTING THE BRAKE PEDAL ADJUSTING THE BRAKESFILLING THE HYDRAULIC RESERVOIR GENERAL MACHINE MAINTENANCECLEANING THE HYDRAULIC SYSTEM FILL HYDRAULIC RESERVOIRSOLUTION CONTROL Recycling or ESP System SOLUTION LOW WARNING LIGHTRECOVERY HIGH WARNING LIGHT SOLUTION CONTROL Non-Recyclingor StandardRECYCLING PUMP STORAGE To service the bladesADJUSTING CASTERS RECYCLING PUMP ESP SYSTEMBATTERY ABBREVIATIONS - SETSCREWS PARTS LIST LEGENDABBREVIATIONS - SCREWS GENERAL TROUBLESHOOTING PROBLEMPROBABLE CAUSE REMEDY1. Worn scrubbing brushes PROBLEMPROBABLE CAUSE REMEDYORDERING PARTS