Nilfisk-ALTO 46/53 manual Hour, Meter, Condition, Position, KEY SWITCH See Figure

OPERATION OF CONTROLS AND GAUGES

	KEY		KEY SWITCH (See Figure 3)
	SWITCH		The keyed ignition switch is located on the instrument
			panel to the left of the side broom lever. The key switch is
			a two-position switch that controls power to the machine
			systems and accessories. The “OFF” position (O position)
			will shut off the machine. The IGN/ON position (I position)
			provides power to the machine and all its systems and
			accessories.
			NOTE
			The operator should never leave the machine
			unattended while it is on.
			FORWARD/REVERSE SWITCH (See Figure 3)
			A two-position switch controls the machine’s direction and
			is located on the righthand side of the instrument panel
		FWD/REV	directly below the key switch. Pushing the upper portion of
			the switch will provide forward motion when the foot pedal
		SWITCH
C1631A-batt	FIGURE 3		is pressed. Pushing the bottom portion of the switch will
			make the machine move in reverse when the foot pedal is
			pressed.
			NOTE
			The machine will not move if:
			The operator is not seated properly in the operator’s
			compartment due to the Seat Switch Interlock safety
			feature; or if the foot pedal is depressed or depressed too
			quickly after turning the key switch on as a result of the High
			Pedal Disable safety feature. (See “MillipaK SEM Controller”)

			COMBINATION BATTERY CONDITION & HOUR METER
			(See Figure 4)
		BATTERY	The combination battery condition and hour meter is
			located on the instrument panel next to the warning bank.
	HOUR	CONDITION	The meter is activated when the key switch is placed in the
	METER	METER	ignition position. The hour meter indicates the actual “run”
			time of the machine and can be used to determine ma-
			chine maintenance intervals.
C1633-batt	FIGURE 4		The battery condition meter indicates the charge level of
			the batteries. The batteries are sufficiently charged if all
	SEAT		the amber LEDs are illuminated during the machine’s
			operation.
POSITION
ADJUSTMENT			If the LED on the far left displays red while using the
	LEVER		machine, the low voltage lockout safety feature will shut
			down the scrub deck’s operation. The batteries must now
			be fully charged in order to reset the low voltage lockout
			and continue the cleaning operation.
			SEAT POSITION ADJUSTMENT (See Figure 5)
			The seat position adjustment lever is located on the right
TO			side of the seat base. The lever is spring loaded to the
		TO ADJUST	“LOCK” position.
LOCK
C-0508a			To adjust the seat, push “FORWARD” on the lever and
			move the seat to the desired position. Then release the
C0508A-2	FIGURE 5		lever to “LOCK” the seat into place.
1-16			American-Lincoln
			ATS 46-53 Battery