![SOLUTION CONTROL (See Figure 14)](/images/new-backgrounds/49748/4974839x1.webp)
OPERATION OF CONTROLS AND GAUGES
| CIRCUTBREAKERS |
| SOLUTION |
| CONTROL |
C1716batt | FIGURE 14 |
SOLUTION CONTROL (See Figure 14)
To apply solution to the scrub brushes, pull the solution control lever back until the desired setting is reached. The solution rate is continuously variable from off to approximately
NOTE
For best results, discontinue application of solution 10 feet before stopping or making a 90° or 180° turn.
NON-RECYCLING OR STANDARD SCRUBBING SYSTEM
1.Make sure the solution control lever is in the “off” (FORWARD) position.
2.Open the solution tank cover (Vacuum Assembly)
3.Fill the tank with 70 gallons of water and the correct mixture of
4.Close the solution tank cover (Vacuum Assembly).
RECYCLING OR ESP & AUTOFIL SYSTEM
1.Make sure the solution control lever is in the “off” position.
2.Connect hose to autofil coupling.
3.Turn the key switch to the “ACC” position.
4.Turn on the water hose valve.
5.Fill the detergent tank with
6.The system will fill the solution and recovery tank to proper levels and shut off the water flow.
TO DISCONNECT WATER HOSE
1.Leave ignition switch in the “on” position
2.Turn the water off at the source
3.“Tip” the float switch on the solution tank to depressurize the water hose before disconnecting
WARNING
To prevent oversudsing and machine damage, use only
DO NOT put gasoline, combustible or flammable material in the solution, detergent, or recovery tanks.
| ATS |