Nokia 6010 Loopset profile, TTY/TDD profile, Automatic Answer, Lights, Select Use loopset Yes

AUTOMATIC ANSWER

This profile lets your phone answer incoming calls after just one ring.

1Place the phone into the car kit holder.

2Select Menu > Settings > Accessory settings > Handsfree > Automatic answer > On.

LIGHTS

If you are using your phone with a compatible Nokia car kit, you can set lights to On (display and keypad lights stay on) or Automatic (after 15 seconds, lights turn off until the next key is pressed or the phone rings).

1Place the phone into the car kit holder.

2Select Menu > Settings > Accessory settings > Handsfree > Lights > On or Automatic.

Loopset profile

The LPS-3 loopset gives people with T-coil equipped hearing aids the ability to make and receive calls without noise interference.

Important: Refer to the booklet that comes with the LPS-3 for complete instructions and safety information.

1Plug the loopset plug into the jack in the bottom

of the phone, as shown in the illustration.

2 Select Menu > Settings > Accessory settings > Loopset.

3 Select Use loopset > Yes.

Note: If you want to use the headset or

TTY/TDD, you perform steps 2—3, then select

No to deactivate the loopset profile.

TTY/TDD profile

You can connect your phone to a TTY/TDD device, using the Nokia phone adapter (HDA-9). In order for your phone to recognize the TTY/TDD, you’ll need to set up the TTY/TDD profile, under Accessory settings.

Important: Some manufacturers of TTY/TDD devices suggest that the phone be least at 18 inches from the TTY/TDD device. Remember that when connecting to any other device, read its user guide or contact its manufacturer for detailed instructions and safety information.

1Connect the TTY/TDD device by a cable to the HDA-9 phone adapter.

50 Copyright © 2004 Nokia