Predefined Channel
Select one of the predefined channel alternatives Predefined Channel.
Adjust Motor
Use the RIGHT / LEFT buttons to adjust the motor angle for selected satellite.
During you adjust the motor by RIGHT of LEFT buttons, if you can find the AGC and BER level is full or higher level,
stop the adjust the motor immediately.
This red bar indicates the average strength of incoming signal for the selected satellite name.
To accuracy alignment, push RIGHT / LEFT buttons slightly .
By pressing OK on the line “ Adjust Motor ”, you can store the adjusted position.
If you finished motor reference setting as you desired, All other preprogrammed satellite positions are oriented relative to selected satellite name.
Motor Limit Setting
Remove Limits
By pressing OK, You can remove east and west limits which were saved before.
East Limit Set Up / West Limit Set Up
You only have to set these limits if the antenna is prevented from reaching its East/West limit positions.
This could be the case e.g. if the antenna is mounted too tight to a wall or in amt similar situation.
Using the LEFT or RIGHT buttons to set these limits, watch the antenna movement and when is has reached its possible limit, set each limit by pressing OK .
Move to Motor Center Position
By pressing OK, You can move antenna to the central position.
Antenna & Satellite Configuration with Motorized System
Once if you have correctly stored the motor reference setting for satellite name, you can use motorized system in this menu. Select the satellite name and LNB type and if you select “ Enabled “on the line “ Motorized System”, you can find motor antenna is going to move to find the incoming signal as to selected satellite name. After motor antenna will find the incoming signal, motor antenna will stop the moving. Also you can find the AGC and BER level with a red bar is shown to full
Automatic, Manual and Advanced Channel Search with Motorized System
After you have stored the motor reference setting and selected “ enabled” on the antenna & satellite configuration.
You can find the AGC and BER level with a red bar is shown to full. in Automatic channel search or Manual Channel search menu
But If the AGC and BER with a red bar level is low, Use the RIGHT / LEFT buttons to adjust the motor angle for selected satellite until AGC and BER level with a red bar is full.
By pressing OK on the line “ Adjust Motor”, you can stored the adjusted position. This position will be the new reference setting by manual adjust motor.
Press OK to start automatic and manual channel search
GB 13
