Reinstall
This will start the Installation procedure from the “Welcome
Menu”.
When you press OK in the “Welcome Menu” again,
be aware of the fact, that all previous channels and settings will be erased! To exit the ”Reinstall” menu without erasing any channels, press “Back”.
System Information
This gives general information about which hardware and software version your Mediamaster is running on.
CONDITIONAL ACCESS
This menu will only be activated if you have inserted a valid Smartcard in the slot behind the front lid.
From here you will get access to information and menus connected to the Common Interface(CA) Module.
This information may vary a lot depending on the Service Provider.
If more than one CA system is activated, select the one from which you want information.
Please see the documentations delivered together with your CA Module.
About Home Transponder
Home Transponder function refers to the Receiver default setting on a home frequency when a code is activated on standby mode. Here, once an access card is detected on its slots, This receiver automatically becomes active and sets to the three Home Frequencies which are as follows;
NILESAT: Showtime Package (11996MHz, Horizontal, 27500Msymbols, FEC=3/4)
ARABSAT: ART & PEHLA package (12604MHz, Horizontal, 27500Msymbols, FEC=3/4)
HOTBIRD: ABSAT package (11681MHz, Horizontal, 27500Msymbols, FEC=3/4)
The STB continuously receives signal even in standby mode so access card automatically becomes active once a new code is sent by the service provider.
GB 26
