Desa DVF36CR, DVF36TCL, DVF36TCR, DVF36TCL, DVF36TCRP, DVF36TCLP Continued, Removing Louver

Installation

Continued

CAUTION: Due to high tem- peratures, make sure wires are not touching upper firebox.

Glass

Locating

Holes

Recommended

Blower Speed

Control

Location

Spring Latch

Figure 33 - Removing Louver

Electrical Hookup for optional blower accessory

Before blower accessory can be operated, the ap- pliance outlet box must be properly connected to a standard 120 VAC power source. This must be done when the appliance is originally installed. Refer to Wiring Diagrams on page 31.

An outlet box with two receptacles has been sup- plied for your convenience and is located on the lower right side of the appliance (see Figure 34). The variable speed controller is mounted on a magnetic base and may be positioned anywhere within an accessible distance behind the louvered opening (see Figure 33).

You may test the blower for operation by turning the control knob clockwise just until it clicks on which is the full on position. Adjust the fan speed to the lowest setting (this should be no more than 1/4 of a turn clockwise).

For Optional

Fan Kit

From Blower

Assembly

Figure 34 - Connecting Blower

Accessory to Power Supply

OPTIONAL Wireless hand-held REMOTE CONTROL Installation

Note: If using an optional wireless hand-held remote control, the wall switch is no longer operational.

NOTICE: Only use alkaline bat- teries (not included).

Installing HRC100 Model Remote Control (Millivolt Models Only)

1.Remove lower louver access panel in fire- place (see step 1 of Wall Switch Installation, page 18).

2.Disconnect wall switch wires from termi- nals marked TH and TPTH (see Figure 32, page 18).

3.Slide 9-volt battery into clip on back of remote receiver and connect battery terminals to bat- tery. Mount receiver onto bracket with clips provided (see Figure 35).

4.Connect white wire to control valve terminal TH and red wire to TPTH. Move remote select switch to REMOTE position.

5.Replace louvered access panel by following reverse of step 1 under Wall Switch Installa- tion, page 18.

6.Remove battery cover on back of hand-held remote (see Figure 36, page 20). Remove and discard sensor tag.

7.Attach terminal wires to 9-volt battery. Place battery into housing.

8.Replace battery cover onto hand-held remote.

9.Set selector switch on receiver to OFF posi- tion if you will be away from the unit for an extended period of time.

Plastic Mounting Clips

9-Volt Battery

Gas Receiver Clip

Valve Terminal

Wires

		LOT
O N		16AI
OT		7	TH
L
I
P
FFO	L		TP
	O	HI
E	A		TPTH

Red	White
	FRONT
To Thermopile

Figure 35 - Installing Remote Receiver

(HRC100)

112108-01C www.desatech.com 19