Installation
Continued
Pilot |
|
|
|
| Pilot Gas Line | |||
Adjustment Cap | ||||||||
Do Not Kink To Pilot | ||||||||
|
|
|
|
| ||||
ON/OFF |
|
|
|
|
|
| Burner | |
|
|
|
|
|
|
| ||
Knob |
|
|
|
|
|
|
| |
|
|
|
|
| O |
|
| |
|
|
|
|
| IL T |
|
| |
|
|
|
|
| P |
|
| |
O | N |
|
| 16AI |
|
| ||
T |
|
|
|
|
|
|
| |
O |
|
|
|
| 7 | TH | To Main | |
L |
| O | O | H | ||||
I |
|
|
| |||||
P |
|
| L | I |
|
|
| |
| FF |
|
| TP |
| |||
|
|
|
| Burner | ||||
|
|
|
|
|
| TPTH | ||
E |
|
| A |
|
|
| ||
|
|
|
|
|
| |||
Inlet |
| Outlet |
| Flame |
|
| ||
Pressure |
|
| Adjustment |
| ||||
| Pressure | Knob |
|
|
Figure 41 - Millivolt Control Valve
5.Figure 45 shows top view of burner and grate.
6.Place logs “A” as shown in Figure 46.
7.Place logs “B” as shown in Figure 47, page 23. Lift end of log “A” that will be propped up and place log “B” under it. At the same time, the other side of log “B” is placed over other log “A”. Repeat procedure for other log “B”.
Open
Close
From
Gas
Supply
E | A |
| O |
| PIL T |
| I |
L | H |
O | To Main |
| Burner |
Figure 43 - Opening Door Latches
| B | C |
D |
| |
|
| |
| A |
|
Flame
Inlet Outlet Adjustment
Pressure Pressure Knob
Figure 42 - Electronic Control Valve
Installing Log Set
Before proceeding, make sure the gas control valve is in the OFF position. Logs have been shrink wrapped on a cardboard backing to prevent break- age during shipping. Cut around perimeter of each log and pull gently on
1.Remove lower louver access panel in fire- place (see step 1 of Wall Switch Installation, page 18).
2.Remove screen rod by sliding it either to the left or right of fireplace until one of the rod ends is free. Remove screen from fireplace.
3.To open glass door, undo latches located on the top and bottom of firebox (see Figure
43). Note: Use caution when opening these latches. Carefully open door by swinging it to the left. The glass door is mounted to the firebox with 5 screws.
4.Figure 44 shows the log set. Logs “A” have a knot at the end of the log. Logs “B” have a knot at the middle of the log. Twigs “C” have the shape of a “Y”. Twigs “D” have the shape of bent twigs. Twig “E” is a straight twig which is placed across top of logs “B”.
E | A |
C |
|
| D |
| B |
Figure 44 - Log Set (9 Pieces) | |
| Left |
Back | Front |
Right
Figure 45 - Burner and Grate (Top View)
| Left |
Back | Front |
Right
Figure 46 - Installing Logs “A” (Top View)
22 | www.desatech.com |