OPERATING FIREPLACE
Continued
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP! Follow “B” in the safety information, page 28. If you don’t smell gas, go to the next step.
7.Turn knob on gas control counterclockwise 
to PILOT.
8.Push in the control knob all the way and hold in. Immediately light the pilot by pressing the ignitor button until a flame appears 1 minute after the pilot is lit. The pilot is located by the main burner. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 8.
•If knob does not pop out when released, stop and call gas supplier.
•If the pilot will not stay lit after several tries, turn gas control knob to OFF and call your service technician or gas supplier.
9.Turn gas control knob counterclockwise 
to “N. Knob can be turned to ON only if the control knob is popped out.
10.Set
11.Turn on all electric power to the appliance.
Gas Control |
|
|
|
|
|
Knob |
|
| O | T |
|
|
|
| IL |
| |
|
|
| P |
|
|
O | N |
| 16AI |
|
|
T |
|
|
|
|
|
O |
|
|
| 7 | TH |
L |
|
|
| ||
I |
|
|
|
|
|
P |
| L |
|
|
|
FFO | O | I |
|
| |
| H |
| TP | ||
E |
| A |
|
| TPTH |
|
|
|
| ||
Position
Indicator Flame Adjustment
Knob
Figure 56 - Millivolt Control Valve
TO TURN OFF GAS
TO APPLIANCE
1.Turn off the wall switch.
2.Turn off all electric power to the appliance if service is to be performed.
Thermocouple
Piezo Ignitor
Pilot Burner
Thermopile
Figure 57 - Pilot
3.Remove control access panel.
4.Push in gas control knob slightly and turn
clockwise 
to OFF. Do not force.
5.Replace control access panel.
Electronic
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information before proceeding.
2.Set thermostat to lowest setting (if appli- cable).
3.Turn off wall switch.
4.Open control access panel or louver.
www.desatech.com | 27 |
