Cleaning and
Maintenance
Continued
3.If replacement is necessary, the entire assem- bly (frame and glass) must be replaced. If glass is broken, wear gloves and tape remaining fragments onto the frame. Remove 5 screws located on end of firebox while holding frame assembly to prevent it from falling and caus- ing injury (see Figure 54). Mount new frame at hinge with 5 new screws. Close and latch door. This will seat the gasket. If replacing end glass panel, remove 16 screws around frame
(see Figure 55) To insure proper fit, when installing new glass panels make sure seam in gasket is placed in the down position.
4.Replace screen assembly and top and bottom louvers.
Hinge
Screws
Figure 54 - Removing Glass Door
Glass
Assembly
Frame
Assembly
Retainer Screws
Louver Assembly
Figure 55 - End Panel Replacement
Operating Fireplace
Millivolt
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information begin- ning above before proceeding.
2.Set the
3.Turn off all electrical power to the appliance.
4.Open control access panel.
5.Push in gas control knob slightly and turn
clockwise to OFF.
26 | www.desatech.com |