8.Apply a thin film of the included
Identify the Right Handlebar (9), which is marked with a sticker. Apply a small amount of grease to the axle on the Right Handlebar, to the Pivot Arm Cover (64), and to the Inner Upright Cover (63). Next, slide the Right Handlebar onto the right Pivot Shaft (15), and insert the axle on the Right Handlebar into the Right Upright (3). Note: Position the Right Pedal (13) near the top of the Incline Ramp (5), and then lift and push the Pedal toward the center of the Incline Ramp while inserting the axle into the Upright.
Place a Wave Washer (100) on the end of the axle on the Right Handlebar (9). Next, apply a small amount of grease to an M8 x 28mm Washer (99), and slide the Washer onto an M8 x 25mm Button Screw (81). Tighten the Button Screw into the axle.
Attach an Outer Upright Cover (74) to the Right Upright (3) with two M4 x 25mm Screws (105).
Attach the Left Handlebar (10) to the left Pivot Shaft
(15)and the Left Upright (4) in the same way.
9.Plug the Power Cord (8) into the Power Receptical
(68)at the rear of the elliptical exerciser.
Next, plug the Power Cord (8) into an appropriate outlet as described on page 10, and calibrate the elliptical exerciser’s incline system by following the steps on page 22.
8 |
|
|
|
| |
|
|
|
| 74 | |
|
|
| 100 99 | 105 | |
|
|
| 63 |
| |
|
| Axle | 81 | ||
|
|
| |||
| 9 |
| Grease | ||
4 | 10 | 64 | |||
|
| ||||
|
|
|
| 3 | |
5 |
|
|
| 15 | |
|
|
|
| ||
|
|
| Lubricate | ||
|
|
|
| 13 | |
15 |
|
|
|
| |
Lubricate |
|
|
|
| |
9 |
|
|
|
| |
|
|
| 68 |
| |
|
|
| 8 |
| |
10.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some extra hardware may be left over.Cover the floor beneath the elliptical exerciser to protect the floor from damage.
9
