Nikon COOLPIXP510BLK, COOLPIXP510RED manual Error Messages, E101, Display Cause/Solution

Error Messages

The following table lists the error messages and other warnings displayed on the monitor, as well as the solutions for dealing with them.

Display		Cause/Solution	A
O	Clock not set.		E75
(flashes)	Set date and time.
Battery exhausted.	Battery exhausted.		18, 20
	Charge or replace the battery.
	Battery temperature is high.
	Turn off camera, and allow battery to cool down before
Battery temperature	resuming use. Five seconds after this message appears, the
	monitor is turned off, and the power-on lamp, the AF/access		25
high
	lamp and the flash lamp flash quickly. After the lamps flash for
	three minutes, the camera turns off automatically, but you can
	also press the power switch to turn it off manually.
The camera will turn	Inside of the camera has become hot. The camera turns off
	automatically.
off to prevent			–
	Leave the camera off until the inside of the camera has cooled
overheating.
	and then turn it on again.
Q	Camera cannot focus.
	•	Refocus.	32
(flashes red)
	•	Use focus lock.	86
Please wait for the	Camera cannot perform other operations until recording is
	complete.
camera to finish			–
	Wait until message clears from display automatically when
recording.
	recording is complete.			Reference
Memory card is write	Write-protect switch of the memory card is in “lock” position.		–
protected.	Slide the write-protect switch to “write” position.
Not available if Eye-Fi	Write-protect switch of Eye-Fi card is in “lock” position.		–	Section
	Error accessing Eye-Fi card.
	Slide the write-protect switch to “write” position.
card is locked.	• Use an approved card.		23
	• Check that the terminal is clean.		22
	• Confirm that memory card is correctly inserted.		22
This card cannot be	Error accessing memory card.
used.	• Use an approved card.		23
This card cannot be	• Check that the terminal is clean.		22
read.	• Confirm that memory card is correctly inserted.		22

E101