3.Slide an M8 x 28mm Washer (99) onto an M8 x 20mm Button Screw (113). Tighten the Button Screw into one end of the Incline Axle (40). Apply a small amount of the included grease to the Incline Axle.
Orient the Incline Ramp (5) so that the straight end is in the position shown. Hold the welded tube on the bot- tom of the Incline Ramp between the two rings on the top of the Frame. Insert the Incline Axle (40) through the rings and the welded tube.
Slide an M8 x 28mm Washer (99) onto an M8 x 20mm Button Screw (113). Tighten the Button Screw into the open end of the Incline Axle (40).
Be careful not to scratch the Incline Ramp (5) during steps 4 through 6.
4.Using your fingers, turn the shaft on top of the Lift Motor (42) counterclockwise until it stops turning. Position the
Next, insert the Short Clevis Pin (118) through the U- bracket on the Incline Ramp (5), the shaft on the Lift Motor (42), and the two Incline Motor Spacers (60).
Insert the straight end of a Hairpin (71) into the end of the Short Clevis Pin.
5.See the inset drawing. While another person tips the elliptical exerciser as shown, place a sturdy piece of packaging foam beneath the elliptical exerciser. Have the other person continue to hold the elliptical exerciser to steady it during this step.
Orient the Rear Stabilizer (2) so that the holes are closer to the front. Attach the Rear Stabilizer to the rear of the Frame (1) with four M8 x 68mm Button Screws (110) and four M8 Split Washers (101).
Carefully remove the piece of packaging foam and tip the elliptical exerciser back down.
3 |
|
|
|
|
5 |
| Straight | 40 99 113 | |
|
|
| End |
|
|
|
|
| Grease |
113 | 99 | 1 |
| |
|
|
|
| |
4 | Front View |
| ||
|
| |||
|
|
| 60 |
|
| 71 |
| 118 | 5 |
|
|
| ||
|
|
|
| |
|
|
|
| 42 |
5 |
|
|
|
|
1 |
|
|
| |
| 2 |
|
| 101 |
|
|
|
| |
|
|
|
| 110 |
|
|
| 110 |
|
7
