Surface Burners
The surface burners are not adjustable. Proper operation is achieved when the correct orifices for the gas supply are installed at the factory, based on model ordered.
*If the top burner does not ignite, check the spark igniter by listening for a clicking sound. If you do not hear the igniter click, turn off the burner. Check for a tripped circuit breaker, blown fuse, or poor wire connection to the igniter.
To Clean Exterior Surfaces
The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth. Any mild glass cleaner will remove fingerprints and smears. Do not use steel wool as it will scratch this surface. Small scratches may be removed by lightly sanding, with the grain, using 120 grit paper.
INSTALLER FINAL CHECK LIST
jPlacement of unit.
jSpecified clearance maintained to cabinet surfaces.
jUnit level - front to back, side to side.
jAll packaging material and tie straps removed.
jLow back or high shelf backguard attached if there is less than 12 clearance above the cooking surface to combustibles behind unit.
Electrical
jReceptacle with 15 ampere
jAdequate ground connection.
jKick panel in place and two (2) screws secure.
Gas Supply
jConnection: 1/2 NPT with a minimum 5/8 diameter flex line.
jSite gas supply is compatible with range model, and sufficient pressure is available (see Gas Requirements on page 10).
jManual gas shut off valve installed in an accessible location.
jUnit tested and free of gas leaks.
Operation
jAll internal packing materials removed. Check drip drawers.
jBezels centered on burner knobs and knobs turn freely.
jEach burner lights satisfactorily, both individually and with other burners on same side of unit operating.
jGriddle is level.
jDrip trays are properly in place and pull out freely.
jOven door hinges seated and door opens and closes properly.
jBurner grates correctly positioned, level, and do not rock.
12
