Jenn-Air 36 Electrical Connections, Power Requirements, LP Gas Requirements, Hook Up, Figure

STEP 4: ELECTRICAL CONNECTIONS

Power Requirements

120 VAC, 60 Hz., single phase.

PRG3010 -	4	Amp. Max.
PRG3610 -	7	Amp. Max.
PRG4810 -	13	Amp. Max.

(Use 15 Amp. Circuit)

Always disconnect electric supply cord from the wall outlet or service disconnect before servicing this appliance.

Observe all governing codes and ordinances when grounding, in the absence of which, observe National Electrical Code ANSI/NFPA No. 70-1990.

Recommended Grounding Method

This appliance is factory equipped with a power supply cord with a three-prong grounding plug (with polarized parallel blades). It must be plugged into a mating grounding type receptacle, and connected to a correctly polarized 120 Volt circuit. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the installer or user to have the existing receptacle changed to a properly grounded and polarized receptacle in accordance with all applicable local codes and ordinances by a qualified electrician. In the absence of local codes and ordinances the receptacle replacement shall be in accordance with the National Electrical Code.

THIS THIRD GROUND PRONG SHOULD NOT, UNDER

ANY CIRCUMSTANCES, BE CUT OR REMOVED.

(SEE FIGURE 9)

Receptacle Box

Cover Plate

Three

Prong

Plug

Ground

Prong

Three Prong

Receptacle

FIGURE 9

STEP 5: GAS REQUIREMENTS

Verify the type of gas supplied to the location.

The range is shipped from the factory set up and adjusted for natural gas or LP gas (propane), depending on model ordered.

Natural Gas Requirements

Connection: 1/2￿ N.P.T. Minimum 5/8￿ dia. flex line.

Pressure: 6￿ to 14￿ W.C.

LP Gas Requirements

Connection: 1/2￿ N.P.T., Minimum 5/8￿ dia. flex line.

Pressure: 11￿ to 14￿ W.C.

A regulator is required at the LP source to provide a maximum of 14￿ W.C. to the range regulator.

Hook Up

A manual valve must be installed external to the appliance, in a location accessible from the front for the purpose of shutting off the gas supply. The supply line must not protrude beyond the back of the unit. Make sure the gas supply is turned off at the wall valve before connecting the appliance.

The gas supply connections should be made by a competent technician and in accordance with local codes or ordinances. In the absence of a local code, the installation must conform to the National Fuel Gas Code ANSI 223.1-Latest Edition.

CAUTION

The appliance must be isolated from the building’s gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5kPa.).

The appliance and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of the system at the test pressures in excess of 1/2 psig (3.5kPa.).

When checking the manifold gas pressure, the inlet pressure to the regulator should be at least 7.0￿ W. C. for natural gas.

**The flex line for the gas supply must be metal and be approved by an approved certifying agency (AGA, CGA, or U.L.). Never use a hose made of rubber or other synthetic material, as the heat may cause the hose to melt and develop leaks.

10