Jenn-Air 30 Do Not Lift The Range By The Oven Door Handles, Do Not Remove The Griddle Assembly

STEP 3: UNPACKING, MOVING AND PLACING THE RANGE

CAUTION

PROPER EQUIPMENT AND ADEQUATE MAN- POWER MUST BE USED IN MOVING THE RANGE TO AVOID DAMAGE TO THE UNIT OR THE FLOOR. THE UNIT IS HEAVY AND RESTS ON ADJUSTABLE STEEL LEGS.

DO NOT LIFT THE RANGE BY THE

OVEN DOOR HANDLES!!

The 36￿ range has a shipping weight of approximately 408 pounds or 354 pounds after removal of packing materials. It is recommended that the door, grates, burners, front kick panel and drip pan (below knobs), be removed to facilitate handling. This will reduce the weight to about 230 pounds.

DO NOT REMOVE THE GRIDDLE

ASSEMBLY

It may be necessary to remove the oven door and knobs to pass through some doorways. With the doors and knobs removed a 29-3/8￿wide opening is required. Without removing the door, a 30-13/16￿wide opening is required. See Figure 3A.

Flex Line to Range

Manual Shut-Off

Valve must be

Easily Accessible

2￿ Maximum

Protrusion from Wall for Gas Supply

FIGURE 4

Kick Panel

FIGURE 5

Remove the outer carton and packing material from the shipping base. Remove the kick panel (see Figure 5) by removing two screws at the top and pulling forward. The range is held to the skid by two bolts in the front behind the kick panel (see Figure 5) and two L-brackets located on bottom flange of the range back (see Figure 7). After removing the bolts and brackets, the range must be lifted and removed from the skid. Due to the weight, a dolly with soft wheels should be used to move this unit. The weight must be supported uniformly across the bottom (see Figure 6).

Range Must be Uniformly Supported on Braces

Leveling Legs

FIGURE 6

7