NordicTrack NTL15007.0 user manual HOW to Turn on the Power, HOW to Personalize Console Settings

HOW TO TURN ON THE POWER

IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.

Plug in the power cord (see
page 11). Next, locate the
reset/off circuit breaker on	Reset
the treadmill frame near the	Position
power cord. Make sure that
the circuit breaker is in the
“reset” position.

IMPORTANT: The console features a display demo mode, designed to be used if the treadmill is dis- played in a store. If the displays light as soon as you plug in the power cord and switch the reset/off circuit breaker to the reset position, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays remain lit, see HOW TO PERSONALIZE CONSOLE SETTINGS to the right to turn off the demo mode.

Next, stand on the foot
rails of the treadmill.	Clip
Locate the clip attached
to the key (see the
drawing to the right),	Key
and slide the clip se-
curely onto the waist-

band of your clothes.

Then, insert the key into the console. After a moment, the displays will light. IMPORTANT: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the posi- tion of the clip.

IMPORTANT: If there is a sheet of clear plastic on the face of the console, remove the plastic. To pre- vent damage to the walking platform, wear clean athletic shoes while using the treadmill. The first time the treadmill is used, observe the alignment of the walking belt, and center the walking belt if nec- essary (see page 26).

Note: The console can display speed and distance in either miles or kilometers. To find which unit of mea- surement is selected, see HOW TO PERSONALIZE CONSOLE SETTINGS to the right. For simplicity, all instructions in this manual refer to miles.

HOW TO PERSONALIZE CONSOLE SETTINGS

The console features a settings mode that allows you to view the total time and total distance the walking belt has moved, select a system of measurement for the console, turn on and turn off the demo mode, se- lect a personal trainer setting, adjust the volume and contrast settings of the console, and select an audio equalizer setting.

Follow the steps below to personalize the console settings.

To select the settings mode, first remove the key from the console. Then, hold down the Stop button while reinserting the key into the console.

When the settings mode is selected, the top of the dis- play will show the total number of hours that the tread- mill has been used and the total number of miles or kilometers that the walking belt has moved.

The display will show the word ENGLISH or METRIC to indicate which system of measurement is selected. To change the system of measurement, press the Speed increase button.

The console features a display demo mode, designed to be used if the treadmill is displayed in a store. While the demo mode is turned on, the console will function normally when you plug in the power cord, switch the reset/off circuit breaker to the reset position, and insert the key into the console. However, when you remove the key, the displays will remain lit, although the but- tons will not function. Press the Speed decrease button to select OFF (to turn off the demo mode), PRO- GRAMS (to display previews of various workouts), ROAD (to display an animation of a runner on a road), or VISUAL EQ (to display a visual equalizer).

13