NordicTrack NTL15007.0 user manual Top, Problem The walking belt slows when walked on

Next, locate the Reed Switch (20) and the Magnet	Top
(12) on the left side of the Pulley (11). Turn the Pulley
	View
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and	29	1/8 in.
the Reed Switch is about 1/8 in. (3 mm). If neces-
sary, loosen the indicated 3/4" Tek Screw (29), move	20	11
the Reed Switch slightly, and then retighten the		12
Screw. Then, reattach the hood. Place the treadmill in
the storage position (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 23). Next, re-
place the two 3/4" Screws (not shown). Lower the
treadmill (see HOW TO LOWER THE TREADMILL FOR USE on page 24). Run the treadmill for
a few minutes to check for a correct speed reading.
PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few min- utes. Repeat until the walking belt is properly tight- ened.

b	3–4 in.
Rear Roller Bolts

c. If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walk- ing belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b.If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

26