2. Identify the Left Upright (73) and the Right | 2 |
| |
Upright (74). |
| ||
|
| ||
See the inset drawing. Tie the wire tie in the |
|
| |
Right Upright (74 securely around the end of the | 74 | 75 | |
Upright Wire Harness (75). With the help of a |
| ||
Wire Tie | |||
second person, hold the Right Upright near the | |||
Right Base Cover (77). Then, pull the other end | Wire |
| |
Tie |
| ||
of the wire tie up through the rectangular hole in |
| ||
75 |
| ||
the bottom of the Right Upright until the Upright | 73 |
| |
Wire Harness is routed completely through the |
| ||
Right Upright. |
|
| |
Gently pull up on the Upright Wire Harness (75) |
| 74 | |
as you set the Right Upright (74) on the Base |
|
| |
(83) inside the Right Base Cover (77). Be care- |
|
| |
ful not to pinch the Upright Wire Harness. |
| 77 | |
|
| ||
Partially attach the Right Upright (74) to the |
| 83 | |
Base (83) with two Upright Bolts (72) and two |
| ||
Upright Star Washers (90). Do not tighten the |
|
| |
Bolts yet. Note: It may be necessary to tip the |
|
| |
tops of the Uprights forward slightly as you |
|
| |
thread the Upright Bolts into the Uprights. |
| 90 | |
Attach the Left Upright (73) to the Base (83) with |
| 72 | |
two Upright Bolts and two Upright Star Washers |
|
| |
(not shown). Do not tighten the Bolts yet. |
|
| |
With the help of a second person, lower the |
|
| |
treadmill off the cardboard stand. |
|
| |
3. Identify the Right Upright Sleeve (96) and the | 3 |
|
Left Upright Sleeve (95). Both are labeled. Slide |
| |
|
| |
the Right Upright Sleeve onto the Right Upright |
|
|
(74) and the Left Upright Sleeve onto the Left | 95 |
|
Upright (73). | 73 |
|
| “Left” | “Right” |
|
| |
|
| 96 |
|
| 74 |
| 7 |
|
