10. Apply a thin film of the included grease to the axles
on the Upright (3) and the Crank Arms (33). Slide a Weld Spacer (49) onto the left axle on the Upright. Make sure that the open side of the Weld Spacer is facing the Upright.
Slide a Pedal Arm Spacer (41) onto the left Crank Arm (33).
Make sure that there are two Rear Pedal Arm
Bushings (11) in the Pedal Arm (12) attached to the Left Handlebar (8).
With the help of another person, slide the Left Handlebar (8) onto the left axle on the Upright (3) while sliding the left Pedal Arm (12) onto the left Crank Arm (33). (Note: These parts fit tightly; it may be helpful to use the rubber mallet. In addition, it
may be helpful to rotate the left Crank Arm [33] to a different position.)
Tap a 5/8” Axle Cap (57) onto the left axle on the Upright (3).
Tap a 3/4” Axle Cap (43) onto the left Crank Arm (33).
Repeat this step to attach the Right Handlebar and the right Pedal Arm (not shown).
10 |
|
|
57 | Apply |
|
| Grease |
|
| 49 |
|
8 | 3 |
|
| 41 | 33 |
|
| |
|
| 11 |
| 12 |
|
| 43 |
|
11.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may
be left over after assembly is completed. | To protect the floor or carpet from damage, place a mat under |
the elliptical exerciser. |
|
9
