7.Connect the Extension Wire (2) to the corresponding wire on the Console (6).
Next, connect the two Pulse Wires (15) to the two remaining wires on the Console (6). Note: Either Pulse Wire can be attached to either wire on the Console.
Next, connect the ground wire to the indicated hole in the Upright (3) with an M4 x 16mm Screw (34).
Carefully feed the wires down into the Upright (3). Attach the Console Base (14) to the Upright with four
M4 x 16mm Screws (34). Be careful to avoid pinch- ing the wires.
8.Find the Left Pedal (31), which has a ridge on the right side. Attach the Left Pedal to one of the Pedal Arms (12) with three M4 x 19mm Flange Screws
(16)as shown.
Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown).
9.Identify the Left Handlebar (8) (there is an “L” sticker on the Left Handlebar). Apply a thin film of the
included grease to the axle on the Left Handlebar.
Make sure that there are two Pedal Arm Bushings (11) in each Pedal Arm (12).
Slide a Handlebar Spacer (39) and the Pedal Arm
(12)with the Left Pedal (31) onto the Left Handlebar
(8)as shown. (Note: These parts fit tightly; it may be helpful to use the rubber mallet.) Next, tap a 3/4”
Axle Cap (43) onto the Left Handlebar.
Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (62).
7 |
|
|
|
| 6 |
Console |
| 14 |
Wires |
| |
| 15 | 34 |
|
| |
|
| 2 |
|
| Ground Wire |
|
| 34 |
34 |
| 3 |
|
| |
8 |
| Ridge |
|
| |
|
| 31 |
|
| 12 |
| 16 |
|
9 |
|
|
|
| 62 |
|
| 8 |
|
| 12 |
|
| 39 |
11 |
|
|
43 |
| Apply |
|
| |
|
| Grease |
12 |
|
|
|
| 31 |
8
