Mounting | Rear Wall |
| |
Plate |
|
Floor
Opening
Optional Supply
Entrance
Refrigerant
Line
Opening
Supply Air Duct
Cut Duct Opening
1/16th. Larger Than
Plenum Connector
Figure 7. Rear Mounting Plate
Mounting
Plate
Plenum
Secure Duct Connector &
Mtg Plate With 2 Flat Head Screws or Nails At Dimpled Locations
Rear Wall
Bend Connector Tabs
Under Duct Opening
Refrigerant
Line
Opening
Supply Air Duct
Figure 8. Duct Connector (Non Platinum)
Method B
1.Place duct connector through fl oor opening with bottom tabs resting on top of supply air duct. Mark cutout area around inside of tabs.
2.Remove duct connector and cut out duct opening slightly larger than area marked.
3.If using optional rear mounting plate (sup- plied with duct connector), install it to back edge of fl oor opening (see Figure 7). Re- install duct connector in fl oor opening. A shim may be used, if necessary, to ensure the furnace is level.
4. Secure duct connector to fl oor with two
fl
5.Secure connector to duct by bending bottom tabs under and up against duct surfaces (see Figure 10).
Method C
1.Attach tabs to sides of duct (one on each side) using sheet metal fasteners or other method, ensuring that the duct connector is secure and sealed to the duct (see Figure 11).
2.Seal the duct fl ap edges with an approved tape or compound for a
12