Chapter 6 Installing the BCM1000e (expansion unit) 81
Installation and Maintenance Guide
Installing the BCM1000e on the wall
The BCM1000e must be installed close enough to the BCM1000 that the 5 m (16 ft.) cable
between the unit and the BCM1000 can be connected without stress on the cable.
Required equipment:
a wall mounting bracket (supplied with the unit)
two #10 x 2.5 cm (#10 x 1 in.) round head wood screws
a plywood backboard 2 cm (3/4 in.) thick
Follow these steps to mount the BCM1000e on wall:
1Install the 2 cm (3/4 in.) plywood backboard on the wall.
2Choose a location on the backboard that is level and leaves enough space on the sides
(23 cm or 9 in.) to insert and remove the media bay modules.
3Use the slotted holes on the wall mounting bracket to mark the location for the two mounting
screws.
4Screw two #10 x 2.5 cm (#10 x 1 in.) screws into the backboard, leaving 6 mm (1/4 in.) of the
two screws showing.
5Align the screw holes between the unit and the wall mounting bracket.
6Fasten the wall mounting bracket using four screws. Refer to Figure 34.
Figure 34 Attaching the wall mounting bracket to the BCM1000e
Caution: Refer to “Environment checklist” on page 69 for acceptable environmental
conditions before selecting a location for the BCM1000e.
Note: If the backboard for the BCM1000 has enough room for the BCM1000e, you do
not require a second backboard.