Nortel Networks BCM1000 Installing the BCM1000e on a flat surface, Connecting the BCM1000e to the BCM1000

82 Chapter 6 Installing the BCM1000e (expansion unit)
N0008587 01
7Align the slots on the wall mounting bracket over the screws.
8Push the unit against the wall and slide it down so the slots rest on the screws.
9Tighten the two screws to the wall mounting bracket.
Installing the BCM1000e on a flat surface
You can install the BCM1000e on any flat surface that can support the weight of the unit, and
which is within 5 m (16 ft.) of the BCM1000.
1Attach the supplied rubber feet to the corners of the bottom of the BCM1000e.
2Position the unit on the table or shelf.
3Ensure that you leave enough space around the unit for ventilation and access to the cables and
media bay modules.
Connecting the BCM1000e to the BCM1000
After the BCM1000e has been installed in the desired location, use the supplied DS256 cable to
connect it to the BCM1000.
1Plug one end of the cable into the DS256 connector on the BCM1000e. Refer to Figure 35.
Figure 35 DS256 connector on the BCM1000e
Caution: Use only the screws supplied with the wall mounting bracket. Do not replace
screws. Other screws can damage the BCM1000e.
DS256 connector