SECTION THREE — Installing the 491
Setting up the echo sounder
Turning the 491 off
For the 957/958/6000i
You must set the navigator’s AUX port to “Sounder”:
1.Press the STAR key to display the OPTIONS/SERVICE INFO screen, then press the PORT SETUP OPTIONS key.
2.Set the AUX PORT option to Sounder, then press the ENTER key.
The STATUS indicator light on the 491 glows steady green when the 491’s power is on and it is communicating with the navigator.
You’ll need to set the echo sounder display options on the navigator’s ECHO SOUNDER SETUP screen. Press the STAR key to display this screen and set these options. For details, see the Northstar 491 Echo Sounder Operations Manual (GM494).
To turn off the 491, turn off the navigator by pressing and holding PWR until the screen goes dark. The 491 will turn off automatically.
Installation test checklist
CAUTION!
If the vessel is out of the water when the echo sounder is turned on, the transducer may be dam- aged. Perform all tests on the with the vessel in the water.
1.Make sure the vessel is in the water.
2.To test the system after installation, turn on the navigator and con- firm that power is on with no errors. If echo sounder data isn’t mov- ing across the ECHO screen from right to left, see ”Common 491 installation problems” beginning on page 21.
PAGE 20 | 491 INSTALLATION MANUAL Revision A |
