Numark Industries DJ Equipment quick start manual Configuring the Virtualvinyl Software

CONFIGURING THE VIRTUALVINYL SOFTWARE

Once you have connected the VirtualVinyl box to your computer and connected the box to your turntables/CD players and mixer as shown in the Hookup Diagram, please install and run the VirtualVinyl software.

Before you can begin playing, you will need to configure the software’s timecode settings. You can access these settings by clicking on the CONFIG button at the top right of the VirtualVinyl software window. This will take you to the VirtualVinyl Settings menu. Please select the Sound Setup tab.

You will see the screen displayed on the right:

1.Under Inputs, select Timecodes if you are using two turntable or CD players.

(You can also mix with only one turntable or CD player. Please see DJing With One Turntable/CD Player section for more information)

2.Under Outputs, select External Mixer.

(If you do not have a mixer, you may choose to use the internal mixer by selecting the Single Output option. If you have a 3-channel mixer, you may wish to use the 3-Lines Mixer option – this will allow you to trigger samples on the third output channel. If you would like to take advantage of this feature, please connect the Output 3 of the VirtualVinyl box to the third channel of your mixer).

3.Under Sound Card(s) you will see VirtualVinyl selected automatically. If it is not selected, please select it from the pull-down menu.

4.Under Input Channels, you can decide which deck each set of inputs is controlling. We recommend leaving them as they are.

5.Under Output Channels, you can decide which outputs of the VirtualVinyl box each deck will use.

6.Lastly, you will need to configure the timecode setting by pressing the TIMECODE CONFIG button. Please see the following section for details on timecode configuration.

5